Your back end is the king as far as the hierarchy of your muscles is concerned so use this guide to power up your glutes. For athletic performance, overall lower body power, strength, speed and everyday optimum function. Honing strength in and activating your glutes should be a top priority in all exercise programs. Your glutes serve as the main mover and power output to most of your major and accessory lifts—squat, deadlift, kettbell swings, box jumps. So the more you develop and stimulate your gluteal muscles, the more you’re able to maximize control, strength, and stability. Below are the top glute exercises to incorporate into your fitness regimen. You can mix and match these in multiple combinations for awesome glute and overall lower body work. Sets and reps for each exercise depends on your particular needs, goals, and current abilities. But, 2-5 sets of 8-15 reps is the option for best results. general recommendation.
1. Standard Bridge (Bodyweight or Loaded)
How to do it: Lie on your back with your feet planted firmly on the floor with your knees bent. If you’re just starting and using your bodyweight, reach your arms straight up over your chest and clasp your hands. If you’re using dumbbells, place the weight on your pelvis and hold it steady. To really activate your glutes, thrust your hips up toward the ceiling, driving with your legs, and dig your heels into the floor. Lower your hips until they’re hovering right above the floor level, then repeat.
Tip: You can add a resistance band just above your knee for glute medius activation. Or place a Pilates ring above your knees for adductor activation, as well.
2. Single-Leg Bridge (Bodyweight or Loaded)
How to do it: Lie flat on your back with your feet firmly planted on the floor, knees bent, as if you’re doing a standard bridge. Keeping one foot fixed to the ground, lift the other up, keeping the bend in your knee. Drive your hips up toward the ceiling, driving through your planted leg and using the raised leg to keep your pelvis even and balanced. Don’t let your non-working leg/side drop, Reames advises, and keep emphasizing the heel plant. Lower toward the ground, then repeat.
Tip: To make it harder, inch yourself close to a wall so your trunk is about a foot away. Bring what would be your “planted” leg on the wall, foot flat against the surface. From here, raise your “non-working leg” up into the air, keeping your knee bent. As you raise up into the glute bridge, you’ll drive your heel against the wall, raising your hips. You can also use a bench. And like the standard bridge, you can up the ante by adding weight.
3. Ball Bridge
How to do it: Begin with your head, neck, and shoulders comfortably fixed against a stability or Swiss ball and both feet firmly planted on the ground, knees bent at 90 degrees. (This is also known as table top position.) Either stretch your arms straight up above your chest with your hands clasped to maximize the balance and stability challenge, or down on either side in case you begin to slip or tip over. As with the other bridge motions, simply lower your hips toward the floor then drive them toward the ceiling. Lower and repeat.
Tip: Try to get your hips parallel to the floor.
4. Single-Leg Deadlift
How to do it: Stand tall with a dumbbell in each hand, arms to your sides. Put some slack in your knees so they’re in a neutral position, slightly bent. Extend one leg back; this non-weight bearing leg should extend straight back until its parallel to the floor, while your planted leg remains engaged and planted firmly to the floor. Your weight-bearing knee should be neutral to just slightly bent to avoiding hyperextension. Sink your arms toward the floor when you draw your elevated leg back, moving with the flow of gravity. Use your glutes to pull yourself back to the upright position.
Tip: Retract your shoulders down your back so they don’t fall forward, Reames says. Also make sure the top of your spine (cervical) stays neutral so your head doesn’t drop.
5. Loaded Bench Bridge
How to do it: Lie with your back flat on the end of a bench and your feet planted firmly on the ground in front of you, knees bent at 90 degree
s. Place a bar (with or without weight) or dumbbells on your pelvis (toward your stomach). Lower your glutes toward the floor, then drive your hips back up to the starting position. Lower and repeat.
Tip: Be careful with your range of motion. Hyperextension of your lumbar spine can hurt your lower back.
6. Prone Hip Extension
How to do it: Begin in a quadriped position so your knees and forearms are on the floor. Extend one leg straight out. Lower this working leg towards the floor, moving from your hip joint. Next, raise your leg high—just before you feel any extension in your spine. Alternate sides.
Expert tip: “Other than your working leg, your body should remain stable throughout the motion,” Reames says. To make the move more challenging, strap on ankle weights.
7. Pistol Squat
How to do it: Stand tall on one leg with your non-working leg in front of you. Dig the foot of your weight-bearing leg firmly into the floor, and bend your knee as you push your hips back. Lower and try to hit the 90-degree range of motion at your knee. Return to start and repeat, alternate sides.
Tip: Try to keep your working knee over your ankle so you don’t jet your knee too far forward.
8. Standard Split Squat
How to do it: Begin with one foot firmly planted in front of you with your other leg extended back. Keep balance by putting your weight in the ball of your front foot and the back heel of your back foot. Hold a dumbbell in either hand, arms at your sides. Or, place a resistance band under the foot of your working leg, up, and around the same shoulder. Stand tall and bend your front working leg to approximately 90 degrees, keeping your knee directly over your ankle so it doesn’t over-extend. Return to the start position and repeat. Do both sides.
Tip: Rest at the bottom of the movement for an extra second.
9. Side-Step Moving Squat
How to do it: Use just your bodyweight, dumbbells, or a resistance band around the top of your knee to activate your glute medius. Assume the same setup of a basic squat, feet shoulder-width apart and knees neutral. Squat down, knees bent at 90-degree angles, and step to the side. Continue repeating this side-step motion down and return to your starting position.
Tip: Stay deep in the squat position, taking wide steps to really activate your glutes.
How to do it: Place steps or a plyo platform directly in front of you. The height should be challenging yet appropriate so you’re not falling. Lean your upper body forward, slightly, and step up, planting your foot and driving the non-working leg up (knee to ceiling). Step back down, then repeat.
Tip: You can work one side first then the other, and/or alternate legs. Keep your upper body leaned forward to incorporate as much weight bearing on each repetition.